Washer for LEADER PLUS offset plates

Description:

Myjnie do płyt offsetowych serii Leader są bardzo wydajne i skuteczne w myciu płyt offsetowych po druku.

Washer for offset plates series Leader are very efficient and effective in cleaning offset plates after printing.

Characteristics of the LEADER offset car wash:

• Maximum width of the offset plate in cm. 68-88-118-138.
• The offset car wash has automatic start of all work phases controlled by a dedicated micro-computer.
• Automatic start of the plate washing cycle using a photomagnetic sensor.
• Offset car wash housing made of powder coated steel,
• Automatic washing cycle with washing liquid with two rotating brushes,
• Automatic rinsing cycle (second section) with one brush movement with an independent motor and hot water washing between the first cleaning section and the third section with rubber rollers. This is a very important washing cycle.
• Adjustable speed of rollers,
• Section with rubber rollers and drying on both sides of the plate with hot air of regulated power.
• All parts in contact with solvent, rubber and hot water are made of stainless steel.
• The internal wash tanks of the offset car was placed in a drawer with a sliding motion of the fluid are completely closed.
• Automatic cleaning cycle for rubber rollers with 2 micron switches for checking the outflow position.
• The last bottom roller is used to drive the plates at the exit from the car wash.
• water recycling with an electric heater.
• Micro-computer control with recirculation of water, water temperature (factory set to +
  / – 35 ° C), counter for cleaning discs (possibility of resetting), automatic power regulation of two heaters:
  A hot air dryer, warning on error display and stages of machine operation.
• green light notification and display of a dedicated micro-computer to insert discs in the queue.
• Capacity of the tank for 40 liters of washing liquid

Attachments:

Gallery: